Ethernet Connection Error Codes

NOTE

This topic describes only module-specific error codes. For details about universal error codes, see Universal Error Codes.

2200001 Invalid Parameter Value

Error Message

Invalid parameter value.

Description

This error code is reported if the parameter value is invalid.

Cause

The input parameter value is not within the valid value range.

Procedure

Check whether the input parameter value is within the valid value range.

2200002 Service Connection Failure

Error Message

Operation failed. Cannot connect to service.

Description

This error code is reported if a service connection failure occurs.

Cause

The service is abnormal.

Procedure

Check whether system services are running properly.

2200003 System Internal Error

Error Message

System internal error.

Description

This error code is reported if a system internal error occurs.

Cause

  1. The memory is abnormal.

  2. A null pointer is present.

Procedure

  1. Check whether the memory space is sufficient. If not, clear the memory and try again.

  2. Check whether the system is normal. If not, try again later or restart the device.

2201005 Device Information Not Exist

Error Message

The device information does not exist.

Description

This error code is reported if the device information does not exist.

Cause

The device to set or obtain does not exist.

Procedure

```bash
> hdc shell ifconfig
```
Check whether the device, for example, **eth0** or **eth1**, exists.

2201006 Device Not Connected

Error Message

Device disconnected.

Description

This error code is reported if the device is not connected.

Cause

The network interface card (NIC) is faulty.

Procedure

View the Ethernet service and netsys logs to check for the connection status information reported by the kernel.

2201007 Failed to Write the User Configuration

Error Message

Failed to write the user configuration.

Description

This error code is reported if an error occurs while writing data to the user configuration file.

Cause

The system reports an error.

Procedure

A system internal error occurs. You are advised to locate the fault based on logs.